|
|
|
|
The personal Protective Equipment at work regulations 1992 require employers to supply Safety Footwear in
hazardous environment.
|
|
|
|
|
|
Impact, heat, chemicals, oil, punctures, static.
|
|
|
|
|
|
|
|
As with all PPE, a comprehensive risk assessment is an essential prerequisite to insure hazards
are eliminated where possible. Where this is not possible the correct Safety
footwear should be supplied and used. We would be pleased to arrange a site survey to assist in the
process of selecting the correct Safety footwear.
|
|
|
|
PRODUCT STANDARDS / CE MARKINGS
|
|
|
|
|
All safety footwear must comply with the new CE markings and approval requirements and meet one of the
following standards.
|
|
|
|
BS EN 345: Safety footwear, 200 joules
toe protection
|
|
|
BS EN 345: Safety footwear, 100 joules
toe protection
|
|
|
|
(Supersedes BS 1870 Part 1
for men’s safety footwear BS4972 for ladies protective footwear.)
|
|
|
BS EN 347: Occupational footwear
BS 46 76: Footwear suitable for use in foundries
|
|
|
|
|
BS EN 345: Safety footwear, 100 joules
toe protection
|
|
|
|
|
|
Sole type
DD-Dule density sole A solid polyurethane outsole for maximum wear and resistance, with soft polyurethane inner cushion for greater comfort.
SD-single density sole Single layer of hard wearing, expanded, lightweight polyurethane.
|
|
|
|
DD Dual density
SDI Single density
PVC PVC air cushion
|
|
|
N,RL Nirtile rubber
VR Vulcanized rubber
NPR Nitrile rubber/polyurethane
|
|
|
|
Steel toe caps
Most styles are to the highest level of protection at 200 joule meeting EN345.
Some styles are supplied to 100 joules meeting EN346, although these are predominantly ladies footwear. Please check the wearer benefits on each section to confirm the level of protection.
Stainless steel midsole
Flexible plate between sole and inner sole to resist nail penetration. Highlighted in the user key in each section.
Anti static
Footwear
made to minimize electrostatic build up by dissipating electrostatic charges through the sole while also insulating the wearer from electric shock.
Code of practice leaflet supplied with each pair. Highlighted in the user key in each section.
Sizes
Most boots and chukkas are supplied in
full sizes 5 - 12. Most men’s shoes are supplied in full and half sizes 5 - 12 (no 5 1/2 or 11 1/2). Ladies boots and shoes are available in sizes 3- 8 with sizes
available 3 to 6 with 1/2 sizes available 3 1/2 - 6 1/2.
|
|
|
|
Sizing
|
|
UK sizes
|
3, 3.5
|
4, 2.5, 2, 5
|
5.5, 6
|
6.5, 7, 7.5
|
8, 8.5
|
9, 9.5, 10
|
10.5
|
11
|
12
|
13
|
|
Metric (cm)
|
36
|
37-38
|
39
|
40-41
|
42
|
43-44
|
45
|
46
|
47
|
48
|
|
|
|
|
To assist in selection we have included a performance table for each product against specific hazards.
The following pictograms are used to highlight specific hazards.
|
|
|
|
|
|
|
|
|
|
|
